Datagram Version Numbers

Hi All,

I recently upgraded some software on a Foundry switch (FES-X448) and
began to receive incorrect datagram version errors from sflowtool (3.6
and 3.7):

The datagram's version being reported by the Foundry was version "0". I
had to modify sflowtool source to decode this version as the standard
source only supports versions 2,4 and 5. For those people more familiar
with the sflow RFC, is version "0" valid? If not I will need to go to
Foundry support and submit a bug.

Many Thanks,

Colin Horsington
TransACT Communications

************************************************************************
*PLEASE NOTE* This email and any attachments may
be confidential. If received in error, please delete all
copies and advise the sender. The reproduction or
dissemination of this email or its attachments is
prohibited without the consent of the sender.

WARNING RE VIRUSES: Our computer systems sweep
outgoing email to guard against viruses, but no warranty
is given that this email or its attachments are virus free.
Before opening or using attachments, please check for
viruses. Our liability is limited to the re-supply of any
affected attachments.

Any views expressed in this message are those of the
individual sender, except where the sender expressly,
and with authority, states them to be the views of the
organisation.
************************************************************************
Received on Mon May 30 14:38:54 2005